成都和泰升降机械有限公司
客户统一咨询热线
139-0802-5849
邮箱:jnhetai@163.com
地址:成都市经济技术开发区成龙大道一段177号
文章来源:www.jnjbrpt.com 发布时间:2023-01-04 14:17:53 浏览次数:1268
曲臂式升降平台http://www.jnjbrpt.com/具有操作简单、使用方便、作业半径大等特点,特别是能够悬伸作业,跨越一定的障碍物或在一处升降,并可进行大范围多点作业,极大的提高了工作效率。下面金臂人升降机械的专家给大家详细分析一下液压泵站的运行禁忌有哪些?
1、在安装运行曲臂式升降平台之前,必须将油箱,管道,液压缸和阀门等清洗干净,灌入油箱的新油必须用滤油机过滤,防止油桶不清洁引起的油液污染。
The new oil before installation and operation of the crank arm type lifting platform must be the tank and pipeline, hydraulic cylinder and valve cleaning clean, poured into the tank must filter oil filter to prevent oil drums clean caused by oil pollution.
2、曲臂式升降平台新泵站在使用一周之后,液油的温度不得超过82°,应将油全部过滤一次,然后根据升降机工作环境和使用频率等情况3-6个月更换一次液压油,清洗一次油箱。
Crank arm type lifting platform of new pumping station after a week, the oil temperature shall not be more than 82 degrees, should be all the oil is filtered once, then according to lift working environment and using frequency 3-6 months to replace a hydraulic oil, cleaning a tank.
3、曲臂式升降平台开始液压回路中使用时需要液压泵具有一定的自吸能力,发生气蚀不仅可能使液压泵损坏,还引起震动和噪声,使得控制阀执行元件动作不良,从而对曲臂式升降平台整个液压系统造成恶劣影响。
Crank arm type lifting platform to hydraulic circuit used to hydraulic pump with a self absorption capacity, cavitation may not only leads to the damage of the hydraulic pump, also caused by vibration and noise, the control valve actuator movement adverse, thus the crank arm type lifting platform for the hydraulic system caused adverse effects.
铝合金升降平台系统的损耗率如何降低?
1、从铝合金升降平台泵站的方面来考虑,考虑到执行器工作状况的多样化,有时系统需要大流量,低压力;有时又需要小流量,高压力。所以选择限压式变量泵为宜,因为铝合金升降平台泵站的流量随系统压力的变化而变化。当系统压力降低时,流量比较大,能满足执行器...
TIME:2023-01-04